Clean work! 😎

That is a seriously nice welding/fit-up table. 🤩 So nice to work with quality tools.

Right On! 🤩 Are you still looking to replace your subframe down the road, or will you continue to tweak the current design? I'm struggli...

I like this new wider version. Keep seeing a picture in my head of a dog with goggles, sitting on it. 😎 😉

Looking Good! 😎

Well deserved. 😎

My favorite part of moving a project out is having the elbow room and freedom to move about w/o damaging or scratching something expensive.

If you can safely support the front tire off the ground, it might be worth checking the wheel bearings again. If the dealer only replaced the one fai...

My pleasure Sir! Maybe they are used on a different sub-model R1100? When I have the rig apart, if I remember, I might trace them down. Would be co...

Those two connectors you asked about, on my bike are not connected to anything. They are tucked and zip tied together just behind the right side plast...

See how much fun you are missing out on! 😎  

You've got quite the project going on! 🤩 Will be very interested to get your thoughts on the 37/11 re-gear. I'm still debating that change....

I was going to do a Subaru swap. 😉 Africa Twin Adventure rig is the ultimate "easy button". 🤩 🤩 Sure hope you are going ...

The Screaming Yellow Zonker is getting an engine replacement. 😎 Finally found what I was looking for (unlike Bono of U2). 23K miles, 1995...

That bench will sure be a nice addition!