Our kit has the center stand lower rear mount, The upper mounts are "universal" frame clamps while the ones we make are much better then the Velorex o...
Set up right you should never have to do frequent alignments, short of being in an accident alignment should not change. There are many issues with th...
In general Ural does not reduce trail on the front of the bike as much as they could so they tend to steer a bit heavier then they could. We have lots...
Honda Ruckus would not be my first choice in a first sidecar rig however it can be done, here is a link to a photo of one we built. I would post my ow...
For information on the Ural, try this link at anther forum. In general 2wd is not really very use full on any thing but a Ural. Urals are heavy, low ...
First off, you are not "Raking" the front end. To rake the front end you would either need to cut the frame and change the angle of the steering head ...
We have the mounts for both the first and second generation Stelvio, so far no one has wanted to have us modify the steering so we have not worked ste...
I ride it at what ever speed I want to go at, Usually about the same speed as every one else on the road as that is the safest speed to travel at. But...
Here are some photo's of a Savage we did, slightly modified from stock. Jay G DMC sidecars www.dmcsidecars.com 866-638-1793 Attac...
You could build a rig however it is a lot less money usually to buy an already assembled rig. If you go this route make sure that it was put together ...
Many auto parts stores rent this sort of puller. Our local Napa store rather then rent them, sells them but as long as you bring it back with in a few...
Keep in mind the cost of mounts when buying a Harley sidecar as Harley is the only company that offers these and they are often not in stock. Mounts c...
We still have a few tops, we may be getting another container load of NOS Sputnik sidecars. They will sell for $2995 and include bike specific mountin...
Of course we do, we also make a leading link front end. The only BMW GS we do not have mounts for is the HP2 as so far every one who has wanted a side...
We find that if your mounts are done well and every thing is stout, the steering head bearings are in good order (some times we will slightly over tig...