Needed a break from working in the attic on wiring, so went rummaging through the Boxes-O-Parts. Lots off good stuff! 🙂 Found the complete paperwo...

That rig looks fast when it is sitting still! 🙂

Thanks Dave! Quick update: Needed a DVM for the BDFH (Broken Down Farm House) project that was in the garage, and on the way back into the house t...

Coming from the automotive world, companies like Scott Drake, Classic industries, etc., make re-pop parts so common an entire vehicle can be built fro...

Thanks for inviting me to participate. It has been fun, and I've learned a few tricks that can be used on other platforms. This software package se...

This is a screen shot from my laptop. Note where files uploaded it shows 32MB on my screen. Probably because I'm special... On a side note: Cou...

Thane brings up a good point. If USCA decides to move forward and change over, it might be a good idea to remind people that their personal settings,...

There are a few different popular forum platforms. It seems relatively easy to deal with the differences, even as a self imposed luddite. From what...

As a test I went to the regular site and copied a picture from Drew's Race Rig build thread. Was able to post it into his thread here. Simple Righ...

Apologies for being a bit late to the party. 😮 Will spend time this afternoon to get acquainted, and start interacting. @Viajero (just ...

My favorite line of the video: "...Disappointingly small amount of struggle." Said right after the transmission practically fell into place. Havin...

It looks like Dnepr Motors could build a custom sidecar to take care of the traffic issues. /p>    

Enjoyed a great ride in the Northern Uintah Basin. This was an out and back, but could turn into a loop very easily, through Vernal, and then fun dir...

finally took the time to replace the left intake manifold. As you can see in the picture below the seal is completely flat. Like it has never had an...