Last seen: September 15, 2026 4:32 am
@miles-ladue Hmm I have a couple of stainless U bolts in my box of stainless bits and pieces. 50mm ID with 10mm course thread if I remember correctl...
A lot of bikes from a different world.
Just a touch cheaper than replacing everything with stainless. And much quicker. Good one Miles.
An oddball bike but they got a surprisingly good review when new. Especially the drive train. But of course it's about the riding not the ride.
Nearly 69 eh? Poor old thing you......... Wait! Mine is in August. When did that happen??? Just do what it takes to sort the clutch and rid...
Two wheels was always fun. But the design was perfected when an engine was added. Carnarvon to Nanutarra roadhouse is 366 klm. Did it on my th...
I do believe I missed this completely. Mine apologies. That said the hinged front Ural tub was done by guy in the Eastern States somewhere. ...
I often wonder how hard it would be to import one then flip it to the other side. Always like the look of those sidecars.
Had to chuckle with/ at FM. I have 4 road registered vehicles at the moment. And that's close to 3 too many give or take one. Road "speeds" Moto...
Mine was originally configured like that but was converted to a single seat with a boot lid. ( trunk ) Also rubber and aluminium trim makes it look ...
It was Bill who made mine for the 650 Strom.. Did the job very nicely. Same Bill? Don't know. Ask Dave Fran.
Reads OK from where I am..............
The basic frame looks set up to be a leaner. The front pivot point higher than the rear. To provide directional input. And only two mounting p...
The thing with salt flats is just that. Flat. How can you run flat out if it's not flat? Pye won't do it. So I'm sticking with the flat earth...