The pad number for a EBC pad should be FA266 and you can get them in all the different materials. I use the V

On my 00 K1200LT with an Astro 2+2 loaded or unloaded I average in the low 40's, I good for 200 miles between fill ups. My 82 Harley I average in the ...

Here's is one reason I like to have spares. No down time in riding and now I have more spare parts to put in good use. Even when things look bad there...

I bring going one step farther I have doubles and triples of most of my setups, you never know when one you let you down. I've being lucky the past mo...

Here is my way. It makes it easy to check the alignment, service, and clean it.

Before jacking it up see if it rolls without much effort. Make sure it's in neutral. Then if it doesn't roll easy lift one wheel at a time to see whic...

You might try Bills Custom Cycles in Bloomsburg PA. He had a bunch of tubs for sale a while back.

I use a piece of 2" Styrofoam insulation between the engine block and board. This way the Styrofoam forms to the block and you not putting all the pr...

The only reason they use slugs it the cheap any easy way out. I do not recommend them and would not use them. I would use the right size fork tubes. S...

Here's to the Happy Harleydays.

This is the new and better way of doing things today. I log on and it took about 2 hours before I could respond to this page. I must have a good healt...

I luck out as my sidecar wheel takes a 13" car tire, but I luck out and found a mag the match the mags that are on the bike. Also all the tires have m...

I you end up with custom wheels for your bike it would be the time to get a matching wheel for the side car. I luck out on my Harley hack as I found ...

Finding one in a 16 matches the rear is going to be a lot harder. The couple that I did end up with custom matching wheels and I can tell you that was...

It would be a lot cheaper just to change the wheel.