Skip to content
John Holbrook
@john-holbrook
Eminent Member
Joined: January 15, 2021 3:59 pm
Topics: 3 / Replies: 16
Reply
RE: sidecar pictures

My rig. 2005 burgman 400 with a 1970's Spirit Eagle sidecar. My grandsons in the sidecar. Pic from the Smokies in 1984 is same sidecar,on a 1...

3 years ago
Reply
RE: TRIUMPH AMERICA / VOLOREX 565

That is an absolutely beautiful bike!

3 years ago
Topic
Replies: 0
Views: 152
Reply
RE: California Sidecar torsion suspension servicing

Jay, this is my Inder clamp. What should I do to it to make it safer?

3 years ago
Reply
RE: California Sidecar torsion suspension servicing

Jay, can you explain the term "cross bolt ?" Thanks

3 years ago
Reply
RE: 2020 now 2021 USCA RALLY, MENA, ARKANSAS

Please post lots of pictures and info!!

4 years ago
Reply
RE: Sidecar sags down

The bike runs 65 mph just fine. Have not been on interstate yet. I need to get more acclimated to the bike before I do that. I have not had a passeng...

4 years ago
Reply
RE: Sidecar sags down

Finally got the sidecar remounted. I added two more struts for strength and stability. Bike and sidecar are doing fine. The little 400 Burgman does ...

4 years ago
Reply
RE: KLR Sidecar Rig Is Sagging

Jay may not see this. Best to contact him directly. Search for DMC sidecars ,and contact him there

4 years ago
Reply
RE: KLR Sidecar Rig Is Sagging

I used typewriter correction fluid to mark all my connections so that if they sag, I know which connection are the culprit. Some people use paint or s...

4 years ago
Reply
RE: KLR Sidecar Rig Is Sagging

Try rotating the two lower eyebolts connected to the bike frame so that the hole is on a flat plane with the ground and the bolt is going thru vertic...

4 years ago
Reply
RE: Welcome to the Sidecar Forums

Yankee, Ingenuity, Dumb luck, and Kentucky windage are a good combination! Nice looking outfit!

4 years ago
Reply
RE: Side car & tug alignment

Can you or have you posted a pic of your outfit? I would like to see it

4 years ago
Reply
RE: Sidecar sags down

Jay, and Chuck, thanks for the advice. I have a welder friend who is going to try and fabricate some similar mounts. The 400 and 650 are completely ...

4 years ago
Page 1 / 2