Sand wouldn't weigh enough. Lead would need sling type hangers as PVC can shatter. Lonnie

I have a new proportioning valve for sale. $50. plus$5.95 priority mailing. As pictured. Lonnie Northwest Sidecars, LLC 208-629-8409 nws...

I believe Vlad was referring to the tongue of the trailer being to one side, not an inside rail hitch. I have made hitches for the sidecar that use t...

Having the tongue pull from one side would cause handling problems. L.

Are you guys using "Screamin Eagle" fork oil too? It helps reduce front end dive. L.

One could build a box from 1/4"x4"x4" angle iron , fill it with old wheel weights and bolt it inside of the rear frame tubee of the chassis under the ...

Take it easy, partner. Give yourself more saddle time. 15 over posted can get you in real trouble if you get too overconfidant. A reduced radius tur...

I use all Amsoil synthetic on my rigs. Greater heat and wear protection and longer life. L.

High performance sport radial. 195/55/R16 Not too many brands offer this size. Cost is about $200.00 less than the Harley 180 Dunlop and it will las...

Proper sized schedule 80 pvc spacers work well. Not just a "drop in" job since the fork springs are under compression and you will need to compress t...

If using weights, place them outboard and to the rear of the axle of the car to keep from dipping the nose in the pavement during a left turn stop. ...

I have run offset front wheels with no bad effects on sidecar rigs in the past. All you would be out if it was problematical would be the labor (and...

Try the B figure. A good test is to turn the bars to the right. Step onto the left peg/footboard holding the grips and pull away from the bike to t...

5" clearance rig is possible but naturally will be limited. No off-roading and maybe slowing down on some tight turns. Most lower mounts here are u...

A 1'x2' piece of 1/2" plate weighs about 40#. You could get all your needed ballast by using a metal deck on the frame. L.