Measure with the gap between the front wheel of the car with the rear bike wheel snug against the rear wheel. Using a straight edge, the front will h...

1 degree to 3degrees. Hannigan has recommended up to 6 degrees for one of their cars I the past which proved to be 3 degrees too much Lonnie N...

Big Island Hawaiian and Pennsylvania Dutch, but here I was using Norski steam power. Lonnie

What is the 52" offset" you mention? Harley has used 8 " to 8 1/2" sidecar wheel lead since the beginning and they are about the same in wheelbase. ...

Yup, Trailer just a tad too narrow for the rig. Didn't want to scratch it up so we Jerry rigged it for clearance. Looked odd but worked well. ...

Rule of thumb, like sidecar wheel lead and lean out. It is a good starting point for a road loaded rig. The final handling is the important thing...

Here are two of the KZP/Velorex 562 rigs we set up with a combination of our mods, brackets and Velorex mounts. Worked just fine with some sidecar bal...

Good lookin' rig, Jay. Those Ducks don't offer much mud protection, do they? Lonnie

This custom V65 Magna Handyman tub (on a CFS chassis also has a flatbed deck under it. Lot's of possibilities for a home boy built sidehack. Rai...

Isn't that a 563 Tour? Lonnie NWSC, Ret'd.

Here is a leftie we came across a few years back. We've also set up a couple others through the years for amputees. Some of the early sidecar fram...

What's the deadline for the Dog issue? Lonnie

2010 was the last year of Harley sidecar production.

A Harley Sidecar Manual is the best source for attaching old cars with the newer Bikes. Often available through Amazon or Harley internet sites. ...

Got it yesterday. Good Job, Guys Lonnie NWSC, Ret'd.