If it is a 16" spoked wheel it must be a Companion model. If so it will probably use a rear wheel (7" hub). The mount set is the same as for the Fri...
You will need a sub-frame mount set to install it on the 2001 Electra Glide. It would be available from CSC. Lonnie
El Bujo, Send me an e-mail and I will give you photos of a subframe you can have fabricated there. Lonnie Northwest Sidecars nwsidecar@aol....
It's doable Karl! But to invert the chassis for a leftie mount will take a considerable amount of fabrication. The frame itself isn't much of a probl...
Jim, You might check with the vendors listed here on the home page. With the sidecar Mfg'r. or any trailer hitch shop can fabricate one for you. ...
I just happen to have a utility sidecar for sale in Boise, Idaho. A URAL Classic sidecar with a new aluminum workbox body. Ready to go, with a new t...
Phelonius post #33688 said: In answer to a question, the rig is a Suzuki S-40 2007 model 650 single engine. All work and fabrication was done by mys...
It's always easier to do the sidecar mounting with the body off the frame. Much easier to access the attachment points. Fine tuning should be done ...
Well said, Claude. Taking into consideration motorcycle manufacturers tolerances and ongoing slight model year revisions; combined with the "Set" th...
Dauntless has never been "Pro Velorex" from the git go. They advertise them for sale but prefer to mount other Russian sidecars, or their own product...
A steering damper from an early Volkswagen Beetle is often used when wobble can't be controlled any other way. Brackets are usually fabricated conne...
There is considerable difference between the FS III and a TLE as far as mounting. Harley uses 3 point mounts, CSC cars use 4 adjustable mounts. I've...
'98 RK/TLE combo with StageII and FI got 40MPG Hiway under 65 and 30MPG at 75. About 35MPG average on the road. Lonnie
The only fault I found was the failure to insert my Shop advertisement on page 19. Lonnie Northwest Sidecars
A good brazed connection at 50K psi tensile strength vs a good welded connection at 60K to 70K psi tensile strength. Either will work well. The m...