Looks like a standard 4 on 4" trailer hub with 1" axle stub and Timken bearings. Measure the offset needed from wheel mounting flange to the swingar...

Build a small set of stairs for the dogs, or a ramp and do a little Mastiff training. Lonnie.

Here's a couple of Bonneville Rigs. Lonnie Attached files

I opted for stock gearing and a Stage II SE big bore conversion. Lonnie

I'm looking at the Bridgestone 195/60/16, 25.3" diameter, 6.1" tread width, or 195/55/16, 24.4" diameter, 7.4 tread width for the rear of my 2010 Stre...

The best mounting position for the damper on a Tubular fork front end is above the slider travel area since there is no change of angle during riding ...

The Storz stuff is waaaaaaaay overpriced. Lonnie

Rick, Mount pix are in my album Hack'ns / Hacks #14. Lonnie

I'd much rather depend on a static balance than a bunch of loose balls rolling around in my tires. Wheel balance weights stay put under acceleration ...

That would be 7' between the fenders. L.

That would be some wide track if it is! L.

The lapbelts used are the same USDOT approved quality as can be purchased from any auto supply outlet. The belts should be attached to a frame membe...

The earlier Velerox 562's came in two models. The 562 Standard which had a fully finished (rounded) cockpit surround and dash with a small steel hand...

The Voyager will make a good solid sidecar platform. It's best to match mounts or sub-frames to the sidecar you choose to mount, new or used. The ...

(Maxim) "be aware that LS650S models come with straight bars not buckhorns," I know the 2008 and later LS650's (C 40's?) have drag type bars but ...