I checked the box originally. I also had checked the box in my reply to Reardan Tom. I just now looked and saw NO such box listed in this thread. L...
Gads, I hate the software editor on this site...and, I need to find out why the site did not send me an announcement of a message. I'll try again...t...
Definitely will be leaving July 4th, probably mid-morning. Finalized my route, it WILL be Hy 50 nearly all the way. Will be a combination of motels ...
I'm hoping it will cool off to even below the average for July, which is 90F
I will be at the same place, the Hotchkiss Inn. So will Al Olme....he's the one that talked me into using a motel....first time, ever. My room rese...
I've still got all three of the hats. I haven't decided whether or not to bring any of them to Hotchkiss. I will bring my 12 volt margarita/daiquir...
Will, I'm a Life Member of MOA, #17058. USCA number is 6504. Robert Fleischer (Bob...or; Snowbum)
Joyce asked me if I could help. UNfortunately, I have not run into that particular problem before. Wildly guessing, can you loosen the disc screws ...
I'm glad that I could offer some help, minimal as it was. For others reading this, the EML chairs used to be relatively infamous for having wheel be...
I failed to mention that if the axle has secondary seizing at the back, that you can heat the assembly to maybe 150-180° F. or even more, and then try...
Your axle is frozen in the bearings. Do not put pressure on the disc, that is not needed. Place some sort of large metallic support at the OUTER casti...