Is it wired correctly? Perhaps the stoplight filiment is working as a tail light. Lonnie

Make sure to recheck your lean-out after you set the toe-in. Lonnie

Unless your pooch is bigger than your wife, carry lots of ballast in the rear of your sidecar to keep from capsizing the rig in right turns. Lonn...

You might check dimensions on the 5.00x16 or 5.50x16. Lonnie

I make my short shields from 1/8" Lexan. It curves easily and is easy to cut with a jigsaw. Lonnie

The Terraplane brake was an optional accessory. They came with or without brakes. The brake was independent of the bike's brake system. Lonnie ...

I have a new body joint edge moulding for the Terraplane. Also have a Terraplane brake assembly with bracket and pedal. Lonnie Atta...

Waaaay before my time Claude! Attached files Kaw Chopper (WinCE).tif (180.4 KB)  Norton Chopper (WinCE).tif (171 KB) 

Outer bearing races.

If you notice an uneven scrub wear pattern to one side it's a good indication of misalignment. Maybe toe-out. Is the sidecar tire wearing evenlywith ...

I would try 3/8" to 3/4" for the toe-in. Set the lean at 1 degree plus with the rig loaded. The old 5.00 X 16" should be OK since the tub is sprung. ...

I would think the only wildlife problems that would be encountered would be if you are to be camping. I haven't been to the Everglades parks but in G...

If the toe-in has been measured correctly and in is specifications any more tweaking to help pull the rig to the left should done by adjusting the lea...

The neck rake and the fork rake have different effects upon steering geometry. I'd go with the raked trees. Lonnie