Maybe it was originally a leaner. In that case it would only use two mounts . Lonnie

California Sidecar Company made the Commutor just for scooters. They went out of production in 2000-2001 since they weren't all that popular (nor we...

The double nickel years were a fiasco and like the present gasohol debacle didn't help mileage or pollution. In the Northwest we are a long ways from...

I think your failure was due tostress on the ungusseted 90 degree butt joint. The weld has held up but the weakness lies in the heat affected zone on...

Check NADA or Kelley Blue books. Lonnie

Like all BMWs since 60's the F650 is lacking in frame access points for sidecar mounting. sub-frame mount assembly will be needed to mount a sideca...

Sidecars in the US are classified as an accessory, not a vehicle. The usual manufacturers liability statutes do apply so their are some things that ...

If the gentleman is able to do his own rigging or has help, I'm sure our good friend Claude can walk him through it. Or will align it for him, Eh, C...

I drill the holes in plastic with a burr, or reverse if using a drill bit. If the edge catches on a drill bit it will split the plastic or start a cr...

Eric, 5/8" Heim Joints are quite sufficient and more affordable. Why are you using these on the upper struts? They are used at the lower mou...

Put some ballast in the rear of the car and be wary of those right hand turns. Lonnie

Stock clutch is the same for sidecar rigs. There are after market replacements if you feel the need. Many change transmission sprockets or go from ...

JR, You're G rated. Lonnie (Geezer)

There are lots of vendors for linear activators (screw jacks) on the net. Lonnie

Russ, I got the 12mm threaded eyebolt from Perry's Motorcycles in Fort Worth, TX. mount the sidecar end of your lower mount like tihs. Lonnie...