The Taraplane used an odd three point mount where the lower mounting arms (pilons is what vetter called them) were not adjustable. We have all of the ...
Dauntless Motors breifly built sub frames this way for use with Ural sidecars. The sub frame did not provide an upper front mount rather it just had ...
If the balls are threaded on, then you can unthread them and we can supply either clevis or eye bolts to thread back in. These sub frames were often m...
Why weld on your bike at all when it is so easy to bolt on hardware? Jay G DMC sidecars www.dmcsidecars.com
Hi Joyce, Most of the time we try and adjust the alignment on the sidecar so that you do not need a damper, First make sure that the mounts are g...
Yes it will pull it however, More important, will it stop it? Make sure you have a brake on the sidecar as there could be times where you do not have ...
They are just standard trailer wheel bearings for a 1 inch axle. NAPA will have a kit with both bearings and the seal for about $18 The part numbers...
I would put the bosses and clamps back onto the sidecar, these are used for a reason, So you can align every thing correctly. With out these, even cha...
Remember to check this with the bikes suspention loaded, I.E. with you on the bike. Jay G DMC sidecars www.dmcsidecars.com 866-638-1793
Your R1100RT needs a fairly exstensive sub frame, we make one that does not require a lot of plastic to be cut, Looks pretty much stock on the plastic...
I agree that the GL1100 is a better bet, I put 150K on one with a sidecar, I would go with a bit heavier stronger sidecar then the Velorex if it were ...
Take the hiem joint off, slide the boss as close as you can to the clamp, Get a large slide hammer (you can rent if need be) Our slide hammer has the ...
The way we do it is in the location like in the grey photo, We cut the back side of the clamp off at an angle so that the front side of the clamp is t...
Remove the crash bar and mount it lower, If you send me an email request, I will email you photo's of the mount installed. Jay G DMC sidecars ww...
We can supply some of the parts for these such as mounting hardware, brake rotors, suspention bushings and a few other items. For windshields we have ...