Originally written by Wngnut on 5/4/2009 8:19 AM Nice mill! Does it come with the CNC controller? If not there is a bunch of stuff on the web to...
Right. It's time to slow down a bit and take it easy if you're not feeling well. Sometimes it helps to take a few days off in any case. When I se...
Originally written by tropicalpete on 5/1/2009 5:38 PM I have a 85 Super Glide with side car , anybody who could give me the best set up specs l...
Originally written by sidecarbrit on 5/1/2009 4:56 PM Its interesting that the rubber work is a little bit suspect- but its only a small thing- ...
As mentioned above, mounting on a crash bar is a really bad idea. You should always connect to the frame or subframe.
Nice work. I have a suggestion. Have you considered rounding off that forward-outermost corner of the frame so that it won't hit on anything when mane...
An excellent group for Goldwing inormation and discussion is the Goldwing Road Riders Association. They have a message board at gwrra.org
I've sold several sets of those U-bolts on eBay in the past few years. They are 7-16" on the threaded portion but they are forged and are extremely st...
Originally written by Spudder on 4/13/2009 9:28 AM Lonnie, trans. is 22 & rear is 51 now & I believe that's as low as I can go there. If...
You could use one triangular gusset at each joint. I was thinking one on top and one on the bottom.
You are definitely going to need some top and bottom triangular gussets where the tubes meet at a 90 degree angle. There is a great deal of strain on ...
Yeah, like Claude says. We're glad to see that you didn't hurt yourself too badly. Take it easy and keep your hands in your pockets. LOL. I have ...
Originally written by Shadow1100T on 4/10/2009 10:44 AM The problem is that you dropped that link and then never made another post until your...
Originally written by Shadow1100T on 4/10/2009 12:14 AM I'd beleive your apologies,,,,,,if you weren't smiling 🙂 The problem is that you ...
Originally written by Shadow1100T on 4/10/2009 2:01 AM With a few exceptions you guys have done a bang up job of Hi-Jacking this post. Oh, ...