Originally written by gnm109 on 3/28/2007 11:20 PM I just purchased a new Harley sidecar. It comes with a formal bill of sale which could be con...
Originally written by james loshbaugh on 3/28/2007 5:31 PM I am looking for just the body. (see the picutres of my sidebox in this forum). The...
We have done quite a few upgrades to Velorexes. When the old shocks are removed from the older velorex sidecar a lot of them come out in two pieces. T...
I always was under the impression that quite a bit of S/TEP training took place in Va.. You should be in luck. Here is some training coming up In...
A cozy can be adapted to many bikes with a little work and weight added.
Vernon, If you are not familar with residual pressure valves you can google the term and get some good info on them and what they do. Basically the...
Originally written by RedMenace on 3/21/2007 9:04 AM Originally written by claude #3563 on 3/21/2007 4:55 AM Vernon, Jay by far has the...
Fact is that any bad news, sadly, will travel faster than good news.Fact is that a problem with typically be 'glorified' more than a good experience j...
We live about on emile off th ehard road. Have run rigid hacks up here a few times and ,yes, they bounce, drag and pitch and roll around quite a bit. ...
Sorry if I mislead anyone.. I am on a roll...lol. Bill...never though you were that weird really but maybe it's just me.
Vernon, Jay by far has the better solution for your project. Much easier hookup as far as lines go etc due to no metric to AN or american fitting c...
I agree with Steve in assuming i tis a Bingahm sidecar. Maybe you will b eable to psot a picture of it at some point. if it is not a Bingham I bet it ...
Just some food for thought. We have noticed on some rigs that a fault in the setup that would typically wear the rear tire will tend to wear the sidec...
I have had good results with Wilwood master cylinders and have used them on a couple of sidecar rigs that had automotive brakes added. Have also used ...
Originally written by SCT100 on 3/18/2007 9:21 PM We just had this discussion on the R3Owners.net. Because of the tire wear associated with a R...