clark22d - 3/31/2010 4:09 PM Ah Ha! Very good info, that will narrow my search tremendously...and is the direction I want to go in. Thanks for a...

Make sure the damper is not set so it maxes out it's travel or bottoms out when the bars are turned. Also if mounted on the lower fork legs allow for ...

Just some food for thought...the dodge k cars (at least some of them) had bolt on spindles on the rear axle. These are cheap and work quite well using...

We usually run a cross brace between the frame rails back there but it can be done in such a way as to retain the toolbox. I suppose many do not do th...

Hack'n - 3/4/2010 4:13 PM You had alignment issues. Try your next tire the other way now that you are aligned and you will have similar results...

Welcome aboard Adam! There are many great folks here at sidecar.com so if you have any questions don't be shy in asking. WARNING: Sidecar fever is...

Hello Lance, Kinda tough to help without being in person with some of these things. You just may benefit by clicking on the link below and seeing i...

>>The stress put on the bike towing the trailer behind the sidecar without sidecar brakes will push the bike more to the left during hard brakin...

The guy from L.A. wrote: >>Is temporary insanity a requirement to have so much fun with sidecars?<< Pedro, You have obvioulsy b...

gnm109 wrote: >>Sure, if it were absolutely necessary to do so, I'm well aware of how to lift the wheel. On the other hand, that will only hap...

This is not the Mazda powered 'roto hack' but it is a similar design with a Peugeot engine. The 'Zeus' by Sidebike Pretty stable eh? And...

That was actually the second incarnation of that bike which was known as the Roto Hack. It was built by Bob Pelican and is powered by a Mazda RX7 ...

We are reps for Hannigan and also Texas Sidecar. Both companies are run by sidecar enthusiats who take a lot of pride in their work and the produts th...

Just some thoughts in picture attached. Also be very careful if you are using heim ends as they will allow movement if not placed correctly at best. ...