Not only welding. Also used screws that bend, coil spring without any nest to sit in, prolonging sleeve on axle, ground clearance below 2", constantly...

Jay, saying about "mounting to swingarm" I have thought about this setup you had to repair. This setup is conglomerate of the worst ideas ...

I'm thinking of this long screw from bike to front j-connector, if it isn't too thin. Velorexes I saw, had original screw much thicker and some shorte...

Jay, doesn't this lower front mount look odd to you? You have seen many better or worse installs in your life, so you can "feel" if it has chance to b...

Give us more photos. If it's properly installed (good parts in good points), it needs only some adjustments that you probably can make within an hour,...

Long wearing tire? If your sidecar doesn't have a brake, just buy Cheng Shin rear 16" tire from/for Chinese 125cc bike. They almost don't wear, will r...

Is your rig already mounted and only needs adjust, or it's in parts and some things must be fabricated? In first case you can try to do it yourself or...

I love welding and I do it better and better. But it must be done really well, with good deep melt and few other "parameters". And with some redundanc...

Bear, if you could see my first rig, that I use until today... Looks like on picture, but after few (or few tens) mechanical experimepts and changes, ...

Your car can be so heavy itself, that with some experience you don't need extra load. My cargo tug's weight, thanks to its special triangulation, is...

If you can, you shold make this plate detachable. This will allow you easier repairs/maintenance/detaching your car and also carrying heavy loads. ...

Maybe you can make a new mounting piece. It should contain two flanges and some pipe cut by angle, everything welded together. Flanges are angled to e...

Yes, I know "Labor of Love" video. Thanks for photos of your tube (Un)fortunately my only car is a sidecar (or trailer). I don't have probl...