I like the idea of the ice chest with circulation pump and heat exchanger. Taking it a step further, could one use this unit as the ice chest and thu...

DMC can be found attoo

There might be something here for you:

Thanks Jay! Email sent.

Thanks all, So mounting the strut low sans crash bar is a good option? I'll be attaching a double-wide if that makes a difference. There is als...

WOW!! Thanks Lonnie & Mike! The photos and the info on dealing with body panels is EXTREAMLY valuable and AMAZINGLY TIMELY!! I have basicall...

I'm in the process of rebuilding my sidecar and am using all LEDs. I'm also replacing bulbs on the tug with LEDs where practical. You may want to sw...

An Auburn Gemini, similar to a TwinStar and/or Ride-by-side. I have a build thread going here in the tech section.

That's what I was hoping to do Mike, but I'm not sure there is enough lower frame exposed to connect both lowers to it. The exhaust blocks much of th...

I have 4 bikes, all vintage Hondas (hence my forum name). In a few weeks, my sidecar will be mounted to my '82 Goldwing and will be my first sidecar ...

I'm getting pretty close to mounting a sidecar to my GL1100. I've been looking over the frame to figure out where to install the shackels with clevis...

Boat, I'll be mounting my sidecar (Auburn Gemini) to a GL1100 over the next few weeks. No subframe is planned.

Looking for some ideas on other approaches to my proposed solutions below. Also sending out a warning to others concerning cheap wiring kits. I ...

The fender is original to the car. The back has a 4-inch hole, so a standard round tail/stop/turn should fit nicely. I picked up a water-proof boat ...