Skip to content
Hack__n
@Hack__n
Famed Member
Joined: June 14, 2003 4:09 am
Topics: 58 / Replies: 4632
Reply
RE: squeaky noise in left turns..

If the holes in the U-clamp strap are obviously elongated, the Eye bolt has been overtightened and strap is not fit for use. A new U-clamp assembly sh...

19 years ago
Reply
RE: squeaky noise in left turns..

Shigeo, Many years ago when I was a bridge painter, an old Railroad inspector showed me how he tested for loose rivets and bolts by rapping them wit...

19 years ago
Reply
RE: '76 FLH Electraglide needs an outrigger/3rd wheel !

Solo use of a bike with reduced trail for sidecar use can result in extreme front end wobble, what is known (to the survivors) as an uncontrollable "t...

19 years ago
Reply
RE: Advice. Want new sidecar for H-D

George, With that response I'd almost bet that you have a Harley tattoo. Lonnie Northwest Sidecars

19 years ago
Reply
RE: Reverse gear

What are the odds against adapting the GL reverse system to the VTX? Just wondering, Lonnie Northwest Sidecars I'm no engineer, but I...

19 years ago
Reply
RE: Level, Carpenters Square, Plumb bob, What Else?

Jim, First: I've successfully set up hundreds of sidecars. Second: For measuring toe-in; I use a 1" wide tape measure, a straight 8' length of ...

19 years ago
Reply
RE: Advice. Want new sidecar for H-D

Doug Bingham's SideStrider Shop is in Van Nuys, CA. He works with most brands. Give him a call at 818-780-5542. Lonnie Northwest Sidecars

19 years ago
Reply
RE: '76 FLH Electraglide needs an outrigger/3rd wheel !

Mike, You might check Ebay or Craigs list for the Harley adjustable trees. Factory Shovel's with sidecars had them and I think the Servicars had the...

19 years ago
Reply
RE: 46 harley's got the shake's, need solution

If you plan on keeping this as a sidecar rig, Get in touch with Pete at Liberty Motors in Seattle. He does the raked trees for Heritage Springers for...

19 years ago
Reply
RE: Wheel Bearing Tool?

"DON'T weld the drills, they will snap in a heart beat, there very hi in carbon and the heat will temper them and they will be as brittle as glass if ...

19 years ago
Reply
RE: Installing SC Mounts On MC Not A Bed Of Roses

Ted, One rotation is still one rotation. The coarse threaded end will just extent farther than the NF or SAE threaded end will at each turn. Lo...

19 years ago
Reply
RE: Installing SC Mounts On MC Not A Bed Of Roses

Jay also has plastic end caps for the clamps and bosses. They don't always fit perfectly so I would recommend sealing them with silicone. Lowe's and ...

20 years ago
Reply
RE: Front Fork & Rear Shock Air Pressure.

The problem with most hand pumps is that there is usually a release of pressure when disconnecting from the schrader valve. The capacity of air shock...

20 years ago
Reply
RE: Front Fork & Rear Shock Air Pressure.

I got my 0-60# pump at Seattle Harley. In retrospect it may not have been a Pingel brand or Pingel doesn't list them anymore. There were two choices...

20 years ago
Reply
RE: Front tires

Linda, I was referring to mounting "Rear" tires in other positions. A designated "Front" tire used as a front tire or sidecar tire should have the...

20 years ago
Page 233 / 313