Skip to content
Peter Pan
@peter-pan
Noble Member
Joined: June 2, 2007 1:59 pm
Last seen: May 15, 2025 12:59 pm
Topics: 91 / Replies: 1942
Reply
RE: Kymco sidecar rig

Hello Steve, Congratulations to the advance in your project. The position of the sidecar wheel looks good now viewing it from other angles. . ...

11 years ago
Reply
RE: Bad head shake

Seabum, That is just part of life in a rig. They all tend to go to head shake at low speeds due to physical forces fighting each other, (some more...

11 years ago
Reply
RE: What Did You Do With Your Sidecar Today?

Edited: "Sidcar, I would love to see your photos from Scotland. Might you repair your post? Just to remember long time ago turns around Lo...

11 years ago
Topic
Replies: 1
Views: 264
Reply
RE: Well I did it.

Congratulations Richard, "Its never too late for a happy childhood!" That is what says my Patrol and how I behave day by day. Playing as a kid. ...

11 years ago
Reply
RE: rear tire

Hello Glen, tires have an internal cloth layer structure and a thread pattern orientated for their use...front tire has to break and as in a tractor...

11 years ago
Reply
RE: Alternative fuel for hack - LPG in gasoline motor

The USA is considering to raise its ethanol content from 10 to 15%... Friends up there. If you do have already trouble at 10% as I experienced o...

11 years ago
Reply
RE: mounting manual for ride by side sidecar on cx500c

Hello Stacy and Rod, A good work horse for a rig. They were very popular in those days. Lasted long and were so reliable we called them the "Güllep...

11 years ago
Forum
Reply
RE: Overloading Velorex 562?

Hey Eli, one point about the Velorex frame: the center support with a clamp often rotates on the frame, then although you have the tensioners set to...

11 years ago
Reply
RE: cycle wheels parallel but offset..

Hello Eli, if your front wheel is more to the left then the back wheel, "between front and s/c wheel) that is possibly a "intended missalignment" ...

11 years ago
Reply
RE: What Did You Do With Your Sidecar Today?

For weeks cats and dogs poring down. Today I stepped out of the door for 30 seconds. Passed the day tinkering with a riding gear drying cabinet I make...

11 years ago
Reply
RE: cycle wheels parallel but offset..

At least aligning a ETZ MZ rig seemed to be like a book with seven seals for me...that pressed sheet metal frame was of such poor quality it bended it...

11 years ago
Reply
RE: Overloading Velorex 562?

Eli, then you have already ex factory, what I try to do with my Jawa "Jolly Roger 2 1/2" I put in a 450 Husquarna "Red Riding Hood" engine. (water coo...

11 years ago
Reply
RE: Overloading Velorex 562?

My Superelastic sidecar on my MZ would have scraped the floor in a fast lefty. (therefore I installed a PE sliding patch in the right front corner.) ...

11 years ago
Reply
RE: Alternative fuel for hack - LPG in gasoline motor

Today I lost about 2 1/2 hours in taxies...the bloody Renault agency made again some nonsense...diesel injection pump fails...one of the taxi drivers ...

11 years ago
Page 29 / 136