Hi Al, One thing to keep in mind toe is only changed when changing the lean out if the lower mounts are not the same distance from the ground, If they...
You have to much wheel lead, not enough toe in. I would drop the wheel lead to around 8 inches, set toe in at around 1 inch. With an automotive tire o...
I have attached some installation information. Jay G DMC sidecars www.dmcsidecars.com 866-638-1793 Attached files BASIC SIDECAR ...
A steering damper hides a front end shake that usually can be addressed with good solid mounts and by getting the alignment spot on. We usually do not...
Hi Colin, We have not made any left side mounts for this bike yet. The R65 is different then most other BMW's while it may look the same it is not. We...
Nothing used, our least expensive sidecar the Kenna $3695 comes with bike specific NOT universal mounts. We can also provide mounts for many used sid...
Make sure that when the sidecar is installed they also modify the front end of the bike, the Kawasaki steers very hard with out steering modifications...
We have done many RT's like yours, we have many sidecars that will work well with this bike, including our least expensive the Kenna as pictured above...
We now have both left and right side mounts for the R1200GSW Jay G DMC sidecars
We build a lot of Triumph Bonneville rigs with our M72DL sidecar. Many people buy the bike new from one of our local dealers, we install the sidecar, ...
Yes we make and stock these. Jay G DMC sidecars www.dmcsidecars.com 866-638-1793
We call the spacers "slippers" and they should have been in both clamps. The only way they would come out is if they were not tight enough in the firs...
We call the spacers "slippers" and they should have been in both clamps. The only way they would come out is if they were not tight enough in the firs...
For what it is worth, We built this rig several years ago. Jay G DMC sidecars www.dmcsidecars.com 866-638-1793
It was about 15 years ago that we did this so I do not remember details. The center stand comes out by loosening a pinch bolt on a clamp an then slidi...