careyjasm01 - 3/15/2010 8:43 AM Thanks for the input. Will start with the car and move inboard then start again. I am also watching a few auct...
George Ryals - 3/12/2010 2:07 PM I am looking for the inner race for the outside wheel bearing. The outside bearing is a needle bearing whose ID...
Shadow1100T - 3/11/2010 2:11 PM I have a mity-vac also and it does a good job of getting fluid out but air floats and that's why I do it in reve...
I use a Mity-Vac unit. It pulls vacuum from the wheel cylinder and removes the air that way. I learned about Mity-Vac when I had a Gold Wing. It makes...
Arthurdillo - 3/10/2010 5:34 PM As some one who still thinks that electricity if some form of black magic - on a boat you can use a small flexi...
Hank41 - 3/10/2010 4:51 AM here goes my twopennies worth from the uk. as you already said unless your bike is pre 81 if you set it up at home yo...
You could easily make a new windshield out of 1/8" Polycarbonate sheet from a plastics store. Polishing them isn't going to be satisfactory. I wo...
The forum was actually upgraded a while back and is much better now as far as loading and usage. I have no trouble posting photos since I use photo bu...
jrapose - 3/3/2010 9:28 AM I have not tried yet...so I really don't know... but from what I have read...it looks like it's just a machined adapt...
Once your custom changeable rig is built, the labor involved at each border crossing to and from the UK areas where they drive on the left side of the...
Once your custom changeable rig is built, the labor involved at each border crossing to and from the UK areas where they drive on the left side of the...
Jane1450 - 3/3/2010 6:14 AM We've searched far and wide for a car tire that will fit a 16" x 3.5" Harley wheel, Yokahama discontinued the only t...
timo482 - 3/2/2010 6:27 PM when a rig is separated is where the trouble has always been... several things are different now... first - buye...
timo482 - 3/2/2010 5:55 PM the bas is required after 2003 - without it the engine shut off sequence can occur easy in a right hand turn if the t...
timo482 - 3/2/2010 5:29 PM reading the new manual.... its a 5 hour deal to remove the sidecar from a bike now and probably 8 hours to put i...