I would think that that the stem would have a flange to stop the it from going too deep into the tree, so one should press out from the bottom of lowe...

I don't know if it will help you any,but when I built my links I moved the axle forward 1 3/4" and it has worked out great on the Goose. I run very ha...

Lonnie, Did not you mean going from a 16" wheel to a 17" would raise the car 1/2", since the height change is only from axle out.

The only negative I can think of is a rougher ride over bumps, because of smaller diameter and stiffer side wall.

W4lnutz, Here's my build and it is still doing great running gravel roads with the faster dual sport riders. It can loose traction in w...

claude, That is what I was saying. After looking at pics of an Earl's, I see that there is a big difference in design from a leading link, as it works...

Jay, Earl's must be different from my LL's, as to move the axle forward, I have to use the hole that is closer to the rear/back of bike. Am I missing ...

RS 486.041 “Motorcycle” defined. “Motorcycle” means every motor vehicle equipped with a seat or a saddle for the use of the driver and designed to tr...

Should not the Earls be in the back holes to reduce trail.

I thought it might of been wider. I think that steering would take some getting used too. I do like.

Honker, how wide is that.

WinginCamera, If the wing trees allow the tubes to be moved up in thru the top adding the longer tubes would allow you to dial in an in between degree...

Got around to building a new nose Saturday out of 5 pieces of 1/8" anodized aluminum sheet. I like this better.

I like and had been thinking of that type with a Fiearo with a v6.