>>in any case i hope the zip ties hold up. i'm concerned about them turning brittle in the cold and snapping. guess we'll see.<< Let ...

Short pieces of chain run around the tire and zipp tied together and to the wheel works pretty good. If the tire is deflated some when they are instal...

al wrote: >>As a bonus, going from 19" to 18" your pick up off the line will improve because of the effectively lower final gear ratio.<<...

Ditto on drilling the frame of the bike...not a good thing. If a through bolt is to be put through a frame tube member the proper method would be to d...

Hackn'. Lonnie, made an important statement in his post thatis manytimes overlooked. >>If the clamps cannot be setup so there is a straight line...

These are much better. Following the links would be interesting too.

Claick on the links too. Claude:-)

David wrote: >>How can I get a hold of one of those wheels? <> What are the risks of taking too much trail out of the front end?<<...

You may want to check this place out: At last count I think there were about 99 Flexitheads there. Hope this helps,

As far as performance increases on the GL1000 there has been things such as superchargers added to them and such but the price of such a thing is not ...

Linda, Maybe you would want to conttact the Georgia Sidecar Club..Good group who is active and has a good time. President: James Allmond ... al...

2"x 2" / 1/8" wall minimum square frame members with 1 1/2" O.D. cross members works well also. The square members can be drilled with a holesaw to al...