Skip to content
Hack__n
@Hack__n
Famed Member
Joined: June 14, 2003 4:09 am
Topics: 58 / Replies: 4632
Reply
RE: BMW R65 Rig setup

562 Velorex is a good match weightwise. It won't bolt right on you will need a sub-frame. Lots of vendors for these. Maybe one near you but at least ...

23 years ago
Reply
RE: Washington State Licensing Changes

Got my new endorsement two weeks ago. Went from a 3 (unlimited motorcycle) to a Grade 7 (2 or three wheels unlimited). Cost was zip, new picture and n...

23 years ago
Reply
RE: home made sidecar

Bob, I used a full size pickup aluminum diamond plate tool box for a body on the last utility rig I assembled. It was a snap to set up, four bo...

23 years ago
Reply
RE: One persons belief that airhead BMW's should not be used for sidecars

Faulkner, The R80 will need a sub-frame to install the hack correctly. If you are going off paved roads the swing-arm and axle should be beef...

23 years ago
Reply
RE: chains for the rig?

Reen, Go down to Bent Bike and pick up a spare rear wheel assembly for cheap. Get some bicycle chain, used if possible, and a chain breaker. ...

23 years ago
Reply
RE: Harley sidecar

The difference is in the mounting attachments. I believe the TLE is used on the FLH models. The RLE is used on the FXR models which used the FLT frame...

23 years ago
Reply
RE: Velorex clamps

Gilles, Looks like you have it sorted out pretty well. You might want to snug up the head bearings a bit to get of what little head shake...

23 years ago
Reply
RE: chains for the rig?

Claude, Are you running those chains longways or sideways? Key-chains or watch chains? Heh, Heh. All seriousness aside I have seen short pieces of...

23 years ago
Reply
RE: Hannigan Lift Seat

Check with Peter Smith at Side Effects. e-mail steerite@sidecars.ca

23 years ago
Reply
RE: K Block Tires

I have a brand new leading link FE complete with steering damper for $575.00. It's listed in the want ads here.

23 years ago
Reply
RE: Velorex clamps

I do not encourage drilling the frame of the (any) bike or the Velorex sidecar to eliminate clamp slippage. I had one instance where a BMW R100R/562 o...

23 years ago
Reply
RE: trail

About 2" or 2 1/2"of trail makes for easy steering. The progressive springs would help relieve front end dive, so will heavier viscosity fork oil, add...

23 years ago
Reply
RE: trail

David, On any bike with a radiator, I would strap it down and compress the front end tubes till suspension bottomed out. That way you can see h...

23 years ago
Reply
RE: Velorex clamps

The Velorex frame "U" clamps will conform to different sized tubing as you tighten them. One half turn after the shim (shoe) contacts the frame snugl...

23 years ago
Reply
RE: trail

If it's working good for you, don't fix it. You can only go down from there. Hang in there Babe!

23 years ago
Page 309 / 313