You might try J.C.Whitney. They have covers for sub-compact cars (MG, Miata, etc.) that would also work for a sidecar outfit.
Jaytree, 860 miles non stop ? WoW!!! You must get a lot better gas mileage that I get with my Harleys. Just Yankin' ya. That's a good hardbut d...
Reloading the URALs & Dneprs with beemer boxers is quite prevalant since they are BMW clones. Why not powder coat the beast? The epoxy coating c...
It can be done but it's not a straight bolt on. The RLEs and TLEs have different mounting systems and through the years all models have changed namel...
Any possibility of installing a 12 volt fan in the nose, ahead of the footrest? That would move about as much air as a vent would, plus it would wor...
Had to wait till Sunday to take my new (Again) VStar rig out for a walk. After clearing my head with a couple of Mike's Hard Lemonades I now see the...
Claude & Mike, This system is widely accepted worldwide and is in extensive use here in the Puget Sound area. It adds an especially nice estheti...
Don't weld mounting tabs onto Japanese frame tubes. The tubes are very thin and the alloys used will break at the weld from the stress of the sidecar ...
Even with a well tuned motor, the extreme altitude changes you encountered would cause excessive richness when at 12+K' especially if you are tuned fo...
You mention 5th gear pulling against the wind or climbing. Altitude alone must not be the problem. A lean mixture could be. Weak spark from fouled or ...
Haven't heard that one. Your '99 Indian is a CMC Harley clone, does it have an S&S motor? A high performance motor will carry higher temps even wi...
Frame joints are not a problem. They make good mounting points for sidecar struts. New Velorex Cruisers or Tour with H-D suspension and 20mm axle work...
That doesn't look like a Liberty. Looks like an old Harley sidecar.
If you are looking for parts like a windshield or the rubber isolator "biscuits", good luck. I made a windshield out of lexan acrylic using a sheet m...
With a Velorex to 1100 VStar installation, I would recommend either one of the new Cruiser models with 20mm axle, adjustable shock and longer swing-ar...