C-mon Bob, Haven't you ever Hijacked a post? Lonnie loling
"Harley is the ONLY Mfg. that makes there (sic) own Sidecars?" "Harley is the ONLY Mfg. that has to safety certify there (sic) sidecar with there (s...
That's about right for a 1200 Shovel with the heavy Harley car. I had a '77 FXS too and I wasn't impressed with the top end as a solo bike. Good looki...
Tell me more about this Gold Wing with the lower center of gravity than a Harley. Lonnie
The magnetic angle guage (protractor) is inexpensive and available at most any hardware or builders supply. I place it on a front brake rotor with t...
Kural, The bottom line here is that a 2 wheel test will demonstrate how well you know the controls of a solo bike but you still won't know S*** abou...
Automotive/Aircraft quality base coat, clear coat Urethane on the exterior and one of the urethane spray on bedliners for the interior works well. Th...
Claude, I am a party (Perp?) to the Washington State "Fiasco". Two years ago at around re-election time, Ms. Mary Margaret Hausen, the C...
At a URAL Homecoming several years ago some unnamed pilots (now well known in the Sidecar industry) were trying to see who could fly the chairs in rev...
Why not check with the Motor Vehicle Licensing Division? They'd know. Some States have no special endorsements for sidecars or trikes, some have tes...
I use a Handy table for solo work but they're not all that handy for combos. You still can't get between the bike and the hack to work easily. For t...
I haven't experienced bump steer unless there was a damper installed. It might help to tighten up the head bearings so you eliminate the flop. A ...
Sarge, I used a MG-TD jack for decades till someone got off with it. It was a short little two stage screw jack that worked great. Lonnie
According to the ad apparently those were sold on 7/27/06. Lonnie
The car seems to be all there and in good condition. The paint color and condition aren't a big issue since few buyers if any would have matching pain...