Sub-frames are bike(and sometimes sidecar)specific. Many Beemer sub-frames are available from vendors listed here linked to the home page. If you a...
Next will be the raked triple trees so that you can really enjoy the rig without sore shoulders. Lonnie
Are you sure they aren't U.S. Army surplus? Here's one I've had since 1946 and still carry in the winter or for off road runs. Lonnie Northwe...
Didn't the Scramblers have higher exhaust pipes? Lonnie
I've worked on a couple of older R models that also had swingarm braces. To eliminate flex? Lonnie
Bob, You are correct. Looking at my rogues gallery I note the front of the frame is still there. The rear section is pretty pathetic though. Remove ...
I believe the 1968 models were the last ones to have a full perimeter frame. The /5, /6, /7 models have a very puny bolt on rear frame section. A...
Use a front or rear tire on the sidecar. If using a designated rear tire, mount it so the rotation arrow is reversed. You don't need driving tractio...
Mark, You're preaching to the Choir here. Many are unhappy at how this legislation turned out. Since you are so inflamed regarding this issue, why...
I've attached quite a few Velorex 562's to the Savage 650's. Standards and Euro models. They are easy to install needing only one U-clamp strap fabric...
The '98 models had a disc brake and were easy to align. Most changes since then have been to the Ultra cars wire loom due to the electronics changes...
Whatever it is, it's metric.
Lonnie is an old geezer who has a small sidecar shop near I-84 off 5 mile road, west of Boise, ID. Recently (re)located here from the Puget Sound rain...
Velorex recommends 2" of threaded bolt inside the strut. 1 1/2" should be adequate for a minimum. Lonnie
URAL/Dnepr cars work well with this bike. You will need a sub-frame to mount it correctly and probably a steering damper if you use the stock front e...