i have progressive glasses - the floor is blurry when i walk but the stuff 300 yds away is in focus but i can now read the speedometer and the st...

the speakers volume is why ive been looking at j&m's - i have trouble hearing cell phone stuff when cooking in traffic - when work calls i have to...

i zip tie the cable fitting to the helmet fitting - that solves that problem - and they hardly ever pull out of the bike half next time i need on...

i intended to lower my bike so i left the spacer out - the liberty spacer is one inch in ht and is a cnc steel mfg that replaces the top nut i ca...

i dont ever ride without a helmet - so the speakers are pointless so what i did was get a 2006 harmon karden ultra sidecar harness, the switch po...

are those the short ultra cushions? to

ok found it - ymmv - and while when looking through the parts on screen these appear to be the proper parts to put a full ultra interior other than th...

yes it will and there is a kit that includes the seat, arm rests, cover, map pockets, knee bolsters - that is less than the seat and the cover. c...

ive had no problems on the front or sidecar - they seem to last as long or longer - handle better, ride better but they dont have the capacity fo...

if you are looking for hd custom wheels - there are quite a few harley wheels that are listed for sidecar use - you have to dig a bit but they are the...

im pretty sure the steel casting that holds the brake, fender & axle is different between the drum brake sidecars and the disk brake ones. th...

my sidecar wheel did not match the bike front wheel in the end - i got a bike front wheel to match the sidecar wheel - cost a hundred dollars new...

actually - i run in 6th quite a bit with my sidecar - if im solo on the two lane back roads its mostly 5th gear - some 6th depending on wind etc.. but...

what ive wanted on my last bike and this one is a deeper first gear running a 15" rear tire gives some reduction - but still a deeper first is th...

i would SERIOUSLY like a hand shift on my ultra - but true handshifts were not rachet tops - they were fixed drums with a rod to the shifter. & th...